Oscillatoscope1d

in stock

Manual Oscillatoscope1d

::ABOUT

It can convert CV and optional audio signals into video and audio, the connector is stereo and works as a multiple

to you can get the same signal you put in out again.

It works by changing the frequency of oscillators that are synced to a composite video sync generator.

The signal that is generated is output as audio on a mono mini jack connector, and as video on the RCA jack connector.

::CONNECTION

inputs:

- power jack: 9v DC + in the center

- 3.5mm mono jack CV A+B: 0 to 5v

- 3.5mm stereo jack starve: 0 to 5v (x to works as multiple feed tru, only the tip is used)

outputs:

- RCA: composite video

- 3.5mm mono jack audio: audio output

::CONTROLS

pots:

- right top: starve (attenuation for CV)

- left bottom: pitch A (range for CV)

- right bottom: pitch B (range for CV)

buttons:

gray 6mm: mid pitch momentary.

gray 12mm left: (off) sync horizontal, (on) sync vatical, (blink) no sync

gray 12mm right: (off) high frequency, (on) low frequency

white 6mm: mid pitch momentary.

white 12mm left: (off) sync horizontal, (on) sync vatical, (blink) no sync

white 12mm right: (off) high frequency, (on) low frequency

black right side: interlaced or progressive.

::STANDARTS

PAL seems to work on all devices i have tested it on.

NTSC works on everything i have tested it on, but in the standard mode it did not work on my video projector, so i added a extra mode that makes it work on my video projector.

the next time you power up it will start up in the mode that was last selected

- PAL hold left 12mm gray button during power up

- NTSC hold right 12mm gray button during power up

- NTSC (video projector hack) hold left 12mm white button during power up